Hello, today i got a PS2 in. It has a Ripper modchip installed, but the component cable doesn’t work, composite’s fine but component not. I have it set correctly to it’s definitely a hardware fault, i opened it up and saw the modchip. When i took a closer look i accidentally ripped out a wire that’s connected to ground, it’s called „RGB link” in the V5/V6 install diagram on the ripper chip website (earliest snapshot). Turns out it was connected to an alternate via, i resoldered it directly to the chip leg because the via was ripped off. Now the console still doesn’t output component, but it also doesn’t boot PS1 games now. It only boots PS2 originals, PS1 originals and backups don’t work. PS2 backups also don’t work. Any suggestions? Should i rewire the modchip up? Replace some components? It’s an SCPH-30004R console, motherboard is GH-015.