Recent content by de9ed

  1. D

    Hacking Help installing picofly oled mod chip

    this is a rp2040 variation read here to get an idea: https://gbatemp.net/threads/picofly-aio-thread.628951/ then read through the guide: https://gbatemp.net/download/a-definitive-picofly-install-guide.37968/
  2. D

    Nintendo Switch Oled Hwfly v5

    This looks like the one that not flashable. It works but slightly slower. I would not try to flash it or even plug in the debug port without risking bricking the chip
  3. D

    switch lite not turning on after hwfly install

    Doesn't matter what firmware. There should be led light. I would get a multi meter and check all the points. Did you use a good mckroscope to check your work ?
  4. D

    Switch Lite ZL always "pressed" (high resistance against GND)

    swap the daughter board was the answer
  5. D

    help with finding switch lite alternative 3.5v pin to install hwfly 4

    the sd card capacitor is pretty big.
  6. D

    Why are Switch modchips so expensive?

    Research and development + Risk and Reward
  7. D

    Hardware Hacking Where can I find oled v4.1 guide instructions?

    I have done the full bga reball for my client. Takes much longer time using paste waiting for it to cool etc. I suggest doing the adapter reflow trick instead.
  8. D

    Tutorial HWFLY chips will brick your OLED. Here is how to avoid it

    I should use the 5 strand one instead. Dont recommended v4.1
  9. D

    Tutorial HWFLY chips will brick your OLED. Here is how to avoid it

    It's just the flashable lite chip with oled wiring. Tempted to buy one for fun.
  10. D

    Help, i'm an idiot and i don't understand

    for overlay, you need tesla loader, tesla menu, and edizon loader. it requires L + D pad down + Right Joycon In to bring up the overlay
  11. D

    Hwfly Oled randomly boots OFW

    Good job
  12. D

    Switch v1 Hwfly

    If it is just RCM mode. Just hold power button to restart. If it is auto RCM on patch switch. I believe RCM loads before the modchip start glitching
  13. D

    Hwfly Oled randomly boots OFW

    Try to use jig and volume up when booting up. To reset the chip
  14. D

    Nintendo Switch OLED - help with component

    It is the 4.7k ohm 0201 resistor. Any variation should work. The switch is not that sensitive
  15. D

    Hacking Looking for someone who can mod a Switch Lite in the region of Montreal.

    If it is a local deal, there is no chance they are paying up front and also handing them the switch (mostly paid after). Dropping off the switch at a personal house address/business address also gives a bit more confidence than dealing at a mall cafeteria/parking lot. A good lesson to learn for...
See more
General chit-chat
Help Users
    D @ diamondsofmayhem: Pleasure to meet you +1