Hello guys,
Got a quick question as i just modded my oled switch with instinct v6 black everything was fine untill the morning i found it frozen and randomly shut down, so formatted the card and tried again all went well even nand dumped fully.
A few mins later decided to restart the device and the instinct turns to white, redid the whole solderjob again and it glitched twice and the third time white so decided to uninstall the pcb and go wire install, but after uninstallation decided to test if console is booting normally and i am getting a black screen.
I have 2 readings which are totally weird, i am getting no reading at the Rst point, that was even when it glitched but all of a sudden stopped getting a reading, second thing 3.3V value i am getting
Below are the readings as is.
3.3 V = 0.034
A = 0.5
B = no reading at all null if i am reading from the switch board but i get a reading on the cap above the point on the instinct chip of 1.5 that is even before the install which was weird but it was working like this marked in Yellow.
C = 0.65
D = 0.6
I attached the photos as well i dont know where to look.
Appretiate an extra eye, i do belive something is off at the 3.3V, shall i try to replace the caps or where to look, noting first time i installed i got an 0.65 reading normally but dont know if QSB messed something up there, because after thst i got very low reading.
I would appretiate anything as i am stuck with a dead mobo now please.
Got a quick question as i just modded my oled switch with instinct v6 black everything was fine untill the morning i found it frozen and randomly shut down, so formatted the card and tried again all went well even nand dumped fully.
A few mins later decided to restart the device and the instinct turns to white, redid the whole solderjob again and it glitched twice and the third time white so decided to uninstall the pcb and go wire install, but after uninstallation decided to test if console is booting normally and i am getting a black screen.
I have 2 readings which are totally weird, i am getting no reading at the Rst point, that was even when it glitched but all of a sudden stopped getting a reading, second thing 3.3V value i am getting
Below are the readings as is.
3.3 V = 0.034
A = 0.5
B = no reading at all null if i am reading from the switch board but i get a reading on the cap above the point on the instinct chip of 1.5 that is even before the install which was weird but it was working like this marked in Yellow.
C = 0.65
D = 0.6
I attached the photos as well i dont know where to look.
Appretiate an extra eye, i do belive something is off at the 3.3V, shall i try to replace the caps or where to look, noting first time i installed i got an 0.65 reading normally but dont know if QSB messed something up there, because after thst i got very low reading.
I would appretiate anything as i am stuck with a dead mobo now please.