Hey everyone, I’ll get straight to the point. I installed the v6 modchip and the training session appeared to have resulted in a success, although the switch screen was not turning on, and the fan wasn’t plugged in so I don’t really know if it died at this point. Anyways I unplugged the battery after the led stopped, and I tried again by this time the keys turned purple then green. I tried to reseed the screen ribbon and attach all the other ribbons and also game card reader, but afterwards the modchip flashed red, then purple, then green. I attempted to then try and turn in the switch with everything removed, which is where I made two mess ups. I ended up lifting the sp1 cap from the apu, and I think I lifted the pads as well but I’m only 70% sure, and I also lifted the two caps at the A point, but I resoldered those and after checking for continuity they seem to be fine. The last thing I think worth mentioning is that I put quite a lot of heat on the caps when resoldering them, and also when initially trying to solder the A point, where I ended up bridiging the two caps and spent almost an hour trying to separate them. This is all I can remember but I may be missing something (I’ve been at this for 8 hours now ), so feel free to ask any additional questions. Thanks