Search results

  1. C

    Hacking Error code 2002-3540

    I just had this issue and I fixed it by removing the 47ohm resistor on the reset line and bridging the connection. I left the 47ohm resistor on the clk and cmd. And left the 330ohm on the dat0. Which is how it came from factory. Works perfectly. The chip in picture is the one I had got from...
  2. C

    Hacking Feedback Error code 2002-3540 Nintedo Switch

    I just had this issue and I fixed it by removing the 47ohm resistor on the reset line and bridging the connection. I left the 47ohm resistor on the clk and cmd. And left the 330ohm on the dat0. Which is how it came from factory. Works perfectly. The chip in picture is the one I had got from...
  3. C

    Hacking Error 2002 - 3540 on a freshly modded Switch

    Where would I find those resistors on this chip? 1706396424 Never mind. I found the solution. No resistors needed changed. The reset resistor(point b) just needed removed and the points bridged.
  4. C

    SD card reader components

    Awesome thank you 1704244619 What size is that cap?
  5. C

    SD card reader components

    So in this case if this is in fact a 0ohm resistor I can bridge the pads right?
  6. C

    SD card reader components

    I think they meant bridging where the missing resistor was.
  7. C

    SD card reader components

    The little components for the sd card reader circuit on back of board(circled in photo-not my photo I borrowed it from google). How important are they? And what are they if one had to replace them? I am missing the second one from the top to be exact.
  8. C

    Please help Hekate won’t load

    I have checked all caps on board. This is the only short I found. Any idea what that chips beside it is for?
  9. C

    Please help Hekate won’t load

    I only get that boot.dat with sx. Not Hekate. Hekate does nothing. I’ve done pc with tegrarcm. It’s says payload was successful. But nothing. I’ve also done other payloads like lockpick etc. All the ones I’ve tried have been either black screen or pink squares everywhere with some txt up in...
  10. C

    Please help Hekate won’t load

    V1. Unpatched. It’s been through some shit. Had it for a month or so. I got it as I non working unit. Replaced the usb c port and that fixed the issue. Since then I’ve had to repair sd card reader and reflow the emmc. But it’s been all good for a couple weeks and then this.
  11. C

    Please help Hekate won’t load

    I have no experience with SXos so I have no idea. I assume probably because the sd card isn’t in and doesn’t have required files.
  12. C

    Please help Hekate won’t load

    See video here on reddit. I have no sd in to see if it would open the basic Hekate.
  13. C

    Hardware Backlight not working on switch v1.

    I have been doing repairs on faulty switch and it now has no back light. It was working but after some trace repairs for sd card reader it is no longer working. I tried cleaning the connector and adding solder to the pins on the flex cable as I had seen others do. But that didn’t work. I...
  14. C

    Hardware SD card reader missing traces

    Hi. I have a v1 switch here that is missing some traces for the sd card reader. I am not sure where they lead. I can do small wire repairs I just need to know where to send them. See red arrows. These 2 are completely gone at the via. Please help. 1678567089 After a lot of searching through...
General chit-chat
Help Users
  • SylverReZ @ SylverReZ:
    Worst would be getting a DRM rootkit from using audio CDs and then Sony getting sued.
  • K3Nv2 @ K3Nv2:
    Least I can throw the nvme at neighbors now
  • DinohScene @ DinohScene:
    get a 2 TB NVMe from amazon, return the fucked one, get replacement and send that one to me
  • DinohScene @ DinohScene:
    : D
  • K3Nv2 @ K3Nv2:
    Easier way buy one with a preadded heatsync pop the heat sync open
  • K3Nv2 @ K3Nv2:
    Some nerd at Amazon warehouse may tell the end of the colors off
  • DinohScene @ DinohScene:
    I'd like a 990 pro tyvm <З
  • K3Nv2 @ K3Nv2:
    Gen 5s going to be crazy expensive at like 10k transfer
  • K3Nv2 @ K3Nv2:
    $300for 2tb
  • DinohScene @ DinohScene:
    don't have anything that can take PCIe5
  • K3Nv2 @ K3Nv2:
    It's still m.2 form just the next gen
  • K3Nv2 @ K3Nv2:
    https://a.co/d/3l0uquC
  • DinohScene @ DinohScene:
    ew crucial
  • K3Nv2 @ K3Nv2:
    13,600 MB/s though
  • DinohScene @ DinohScene:
    I got a 980 pro iirc
  • K3Nv2 @ K3Nv2:
    Soldigms been pretty solid
  • DinohScene @ DinohScene:
    yeh 980 pro
  • DinohScene @ DinohScene:
    good enough tbf
  • K3Nv2 @ K3Nv2:
    https://a.co/d/gMNhZNI never heard about them but reviews are good
  • SylverReZ @ SylverReZ:
    @DinohScene, Crucial SSDs work fine. I have one installed in my Xbox.
  • SylverReZ @ SylverReZ:
    Reviews seem positive.
  • DinohScene @ DinohScene:
    I believe I had some Patriot RAM running in a computer somewhere
  • K3Nv2 @ K3Nv2:
    $250 is pretty solid considering
  • K3Nv2 @ K3Nv2:
    With the refund it'll be about $150
  • K3Nv2 @ K3Nv2:
    6tb nvme pc ftw
    K3Nv2 @ K3Nv2: 6tb nvme pc ftw