Search results

  1. bombob

    Hardware Cant boot RCM with LCD screen connected

    Hello I have a nintendo switch board that have been worked on (not by me). It will load any rcm payload but not with the lcd or the backlight ribbon connected. with only the backlight connected it would just flash for a second and shutdown right away. With both lcd and backlight there would be...
  2. bombob

    Hardware Switch shuts down after nintendo logo

    Hello I have a v1 switch that wasnt booting and was charging at 0.4A. had a short around the p13usb. Changed the chip and it booted fine but wasnt docking. took it apart again and found one of the hdmi filter coils that was faulty. Replaced it and it still wouldnt dock.but all of a sudden it...
  3. bombob

    Hardware Rebuild emmc from scratch?

    I recently came across a switch that wouldn't power on but when I connected it to the usb tester it was drawing amps thus charging. I then proceeded to try some payload and none of them was able to read the nand. I have another unit and tried to swap out the emmc module just to make sure there...
  4. bombob

    Hi all

    Hello everybody. I have been reading and using info from this forum but I never was part of it. I think its really unfair to be a leech so here I am :) I do a bit of electronics (soldering,reflowing) but I am constantly learning
General chit-chat
Help Users
  • No one is chatting at the moment.
    SylverReZ @ SylverReZ: @HiradeGirl, Hi