I unbricked my Switch from an empty eMMC using Sthetix's guide.
Everything looked fine, but when I opened TegraExplorer,
the screen displayed the message 'Grabbing keys from prod.keys ... done.'
and I couldn't do anything else.
1715655417
I...
however able too boot in or not.
i mod it with picofly. and plug USB in without connect battery or display or anythings.
picofly start to run and
error code : *=* No eMMC block 0 read (eMMC init failure?)
actually before i got short everywhere i...
can you give me the ground position ?
i may put and fill it with some solder ball.
update:
i decide to remove EMMC because M92T36 short, PI3USB short, 3v3 rial Short.
after i remove EMMC all short gone.
now i has been replace it they are no any...
Is this the end ?
Or i have a chance ?
any advice please.
I tot i will use stencil tool to apply solder paste in to these hole and reballing
them first on socket, is this a good idea?