I unbricked my Switch from an empty eMMC using Sthetix's guide.
Everything looked fine, but when I opened TegraExplorer,
the screen displayed the message 'Grabbing keys from prod.keys ... done.'
and I couldn't do anything else.
I reinstalled the HATs pack, and now I am able to go into TegraExplorer.
However, I still can't use it. It looks like my volume up button is stuck.
No matter if I remove the power(+ vol) flex cable or not, the volume up button remains stuck.
this is so bad.
And now my volume button works properly.
After I removed the battery, I prepared to clean the motherboard.
I gave it a test before I began cleaning,
but the button started functioning again.
Here are the steps to reproduce solution:
Everything looked fine, but when I opened TegraExplorer,
the screen displayed the message 'Grabbing keys from prod.keys ... done.'
and I couldn't do anything else.
Post automatically merged:
I reinstalled the HATs pack, and now I am able to go into TegraExplorer.
However, I still can't use it. It looks like my volume up button is stuck.
No matter if I remove the power(+ vol) flex cable or not, the volume up button remains stuck.
this is so bad.
Post automatically merged:
And now my volume button works properly.
After I removed the battery, I prepared to clean the motherboard.
I gave it a test before I began cleaning,
but the button started functioning again.
Here are the steps to reproduce solution:
- Confirm the volume button is malfunctioning.
- Remove the power flex cable from the motherboard while the screen is on.
- Remove the battery while the screen is on, causing the console to shut down, then reconnect the battery cable.
- Short circuit pins 1 and 3 to reopen the console.
- Plug the power flex cable back in.
- Restart a couple of times to check, I dont know why but its work.
Last edited by speed365inter,
no. 
just having fun.
