Can't boot on picofly hekate after 16.0.3 update

[AspenFTW]

Hi After updating to OFW 16.0.3 and updating atmosphere, hekate, sigpatches, fusee I can't boot to hekate. It's always booting to OFW. I'm using picofly v2.67

Do you guys know what's the issue here?

 

[Kagami-san]

Hi After updating to OFW 16.0.3 and updating atmosphere, hekate, sigpatches, fusee I can't boot to hekate. It's always booting to OFW. I'm using picofly v2.67

Do you guys know what's the issue here

I had the same issue. You have to pull out your jig and use TegraRCM and press the volume up button along with power when you turn on the console. Turn console off, put jig in, open TegraRCM and autoload hekate payload (make sure u have USB driver installed) and finally, plug the USB cable into your switch while your holding down the volume up until you see it boot into hekate. You may have to hit the power button as well to turn it on

Post automatically merged: Wednesday at 2:35 PM

I had the same issue. You have to pull out your jig and use TegraRCM and press the volume up button along with power when you turn on the console. Turn console off, put jig in, open TegraRCM and autoload hekate payload (make sure u have USB driver installed) and finally, plug the USB cable into your switch while your holding down the volume up until you see it boot into hekate. You may have to hit the power button as well to turn it on

i dont know how picofly differs, maybe u dont need a jig? maybe u just need to press volume up

 

[AspenFTW]

Thank you. Volume up + power button worked. I've also got 1 report from a friend that modding picofly on v16.0.3 switch is hard. Sometimes it's not glitching on first install but once it glitch, it will work fine.