Hacking Switch won't boot after choosing fusee.bin. AutoRCM is on but isn't detected on PC and Android.

[ereh69]

Updated the switch firmware earlier this day. Added new atmosphere version and sigpatches and then when I booted fusee.bin, it showed the sept logo for a few seconds and then it just turned into a blackscreen. Like full black, no backlight. Looks like it's just dead. The switch was fully charged. Tried connecting it to a PC, and on my android phone. No luck detecting any RCM. The switch was also on autoRCM and have been using it for a year with no problems. Haven't tried to use the jig cause I left it on my friend's house. Dk if it'd work with the jig since the switch is on autoRCM.

Bottomline is, switch appears to be dead after updating and booting. No signs of detection when connected to pc and android. Rekado or tegrarcmgui doesn't detect anything at all.

Any idea how to fix this or what might have happened?

 

[Spider_Man]

updaate fusee.bin and bootloader, remove autorcm because its pointless. dont update console firmware as that also is pointless, just update your cfw/bootloader/sig patches.

fully power down console.

delete all cfw files/folders from sd card

download latest files for cfw/sigpatches/bootloader from the official githubs and put onto sd card.

fresh power boot console into RCM and select fusee and it should boot.

Also, never update console firmware unless cfw update is confirmed working properly, also never update official firmware using the normal methods, download OFW and use daybreak to install as this prevents fusee burns, so if shit hits the fan and you have a backup, you can simply revert back.

 

[Draxzelex]

Updated the switch firmware earlier this day. Added new atmosphere version and sigpatches and then when I booted fusee.bin, it showed the sept logo for a few seconds and then it just turned into a blackscreen. Like full black, no backlight. Looks like it's just dead. The switch was fully charged. Tried connecting it to a PC, and on my android phone. No luck detecting any RCM. The switch was also on autoRCM and have been using it for a year with no problems. Haven't tried to use the jig cause I left it on my friend's house. Dk if it'd work with the jig since the switch is on autoRCM.

Bottomline is, switch appears to be dead after updating and booting. No signs of detection when connected to pc and android. Rekado or tegrarcmgui doesn't detect anything at all.

Any idea how to fix this or what might have happened?

Have you tried leaving it on overnight and charging it?