Hardware Misc In jailbreak Mode joy cons can’t Connect

[marcello7130]

Hello if I don't have my Nintendo Switch in jailbreak mode, the joy cons also work outside of jailbreak. But when I jailbreak my switch, the joy cons don't work when I disconnect them from the Nintendo Switch console. Do you have Solution for these problem?

 

[Hayato213]

update joycon firmware.

 

[HeartFullaNapalm]

I've not had this issue with Atmosphere. Are you maybe setting your Switch into airplane mode when going into custom firmware?

 

[Shadow#1]

I've not had this issue with Atmosphere. Are you maybe setting your Switch into airplane mode when going into custom firmware?

I bet that's it

 

[Shadow#1]

@marcello7130 u need proper blockers enabled

https://rentry.org/ExosphereDNSMITM

 

[marcello7130]

update joycon firmware.

Same problem

 

[marcello7130]

@marcello7130 u need proper blockers enabled

https://rentry.org/ExosphereDNSMITM

I will try that tomorrow

 

[marcello7130]

I've not had this issue with Atmosphere. Are you maybe setting your Switch into airplane mode when going into custom firmware?

What do you mean exactly?

 

[impeeza]

supposed talking about not get banned by going online on a Hacked Switch, you need to read about the 90DNS and Atmosphère LAN MITM protections.

 

[oldsk00l]

Maybe this Guide will help you to solve your problem with the joycons. But watch out for the warnings and read the guide carefully.

 

[DJPAUL1990]

I had the exact same problem yesterday. (Airplane mode was off and joycons were uptodate)

What helps me: i deleted the joycons and synchronize it again. Did this about 10 times till it works.

 

[marcello7130]

I had the exact same problem yesterday. (Airplane mode was off and joycons were uptodate)

What helps me: i deleted the joycons and synchronize it again. Did this about 10 times till it works.

That helps me thank you 😊

 

[Rasa39]

It's been a while but iirc whenever I switched from emunand to sysnand my joycons would only work wirelessly on one or the other. I believe this is because it treats the emunand as a different switch as far as the joycon connection is concerned. Like they are paired with one nand, not the other.

So as long you don't have airplane mode on, you have to resync them wirelessly every time you switch between nands. Only way to avoid it is to leave them docked on the switch and it will auto detect them when connected but only while they are connected, not wireless.