Hacking Hi everyone Please help, I haven't solved my problem yet

[banging]

As I mentioned earlier I have a problem with the Xbox 360e (corona4g v4)
The device does not boot in to the system , it just boot in to xell. I tried to flash updflash.bin via USB, but it doesn't read it . It just reads xenon.elf with the nandflash.bin file, but it stops At first glance and turns off the device.
My question is, can I fix the fault with the MTX SPI NAND Flasher v1.0 tool ?
Is this method in this image can do that? :
thanks

 

[godreborn]

you could try the debian disc. I can't recall if that's the reason I used it or not or it wouldn't flash through xell after a bad flash. it will create a wireless link to the system from your pc, where the debian disc will be used. I can't recall the specifics though, but I do have the disc. I'm also not sure if it has to be on a certain firmware:

 

[HollowGrams]

As I mentioned earlier I have a problem with the Xbox 360e (corona4g)
The device does not boot in to the system , it just boot in to xell. I tried to flash updflash.bin via USB, but it doesn't read it . It just reads xenon.elf with the nandflash.bin file, but it stops At first glance and turns off the device.
My question is, can I fix the fault with the MTX SPI NAND Flasher v1.0 tool ?
Is this method in this image can do that? :
thanks

16mb corona and any nand flasher should help you out
4gb corona you will need a 4gb r/w kit

Some coronas need r1r1 resistor removed, bridged, or grounded in order to boot dash.


https://www.se7ensins.com/forums/th...ang-in-the-first-3-5-glitch-attempts.1733481/

 

[godreborn]

^^ that might work better if it's hardware related.

 

[banging]

16mb corona and any nand flasher should help you out
4gb corona you will need a 4gb r/w kit

Some coronas need r1r1 resistor removed, bridged, or grounded in order to boot dash.


https://www.se7ensins.com/forums/th...ang-in-the-first-3-5-glitch-attempts.1733481/

Thanks everyone for the reply :
Hologram :؟
how i ground the resetor I don't want to risk removing it

thanks

 

[HollowGrams]

Thanks everyone for the reply :
Hologram :؟
how i ground the resetor I don't want to risk removing it

thanks

Solder a wire from one side of R1R1 to ground point copper trim around motherboard. Doesn't always work but does for some E models.

 

[banging]

Solder a wire from one side of R1R1 to ground point copper trim around motherboard. Doesn't always work but does for some E models.

ok thanks