Hexagon Atmosphere Black Screen after restart

[LittleSeki]

Hello,

first of all sorry for my english xD
Than i am all new to this stuff.
I installed hexagon with atmosphere with tegraRCM.

I was able to install tinfoil and verything works, i can start the homebrew store as well.
I did a backup in hexagon form the sd card before i startet for safty, and turned AutoRCM ON.

No my problem is, if i turn my switch off and want to turn it on, the screen stays black.
I have to connect it to my pc and run hexagon with tegra again to load the switch.


My sd card is in Fat32 format.

What infos or screenshots do you need to help my, like installed files and so?

I hope you can help me,

Post automatically merged: Feb 10, 2023

I ordered a new micro sd card now, because i got tinfoil errors with failed to register placeholder nca

so i hope it is only the sd card.
I will updated after i tried it.

 

[binkinator]

Hello,

first of all sorry for my english xD
Than i am all new to this stuff.
I installed hexagon with atmosphere with tegraRCM.

I was able to install tinfoil and verything works, i can start the homebrew store as well.
I did a backup in hexagon form the sd card before i startet for safty, and turned AutoRCM ON.

No my problem is, if i turn my switch off and want to turn it on, the screen stays black.
I have to connect it to my pc and run hexagon with tegra again to load the switch.


My sd card is in Fat32 format.

What infos or screenshots do you need to help my, like installed files and so?

I hope you can help me,

Post automatically merged: Feb 10, 2023

I ordered a new micro sd card now, because i got tinfoil errors with failed to register placeholder nca

so i hope it is only the sd card.
I will updated after i tried it.

It sounds like you have AutoRCM enabled in Hekate. This will “break” your boot process on purpose so it will drop into RCM mode and allow yiu to inject a payload. Turn off AutoRCM and it is likely your Switch will boot directly into official stock firmware.