Hardware Help identify 2 missing component

[Nagaa]

Hello,
I have a customer switch v1 to repair with prior attempt on the USB C Port with a lot of missing pad,
i replace the M92T36 and restored the pad needed to get charging on both side and the USB Data line to get RCM injection working
It work i got fast charging on both side, but no detect when plugged in RCM mode and i found out the USB Data line D+ was reading OL on the motherboard so not a soldering problem (same issue on D- here)

I inspected the board to see if i can found where the problem coming from when i found 2 missing component :

I don't have any value for this component from what i can see it's a diode and a capacitor ?
Can it be related with the problem above because apart the usb problem the switch work fine but the customer really want to get rcm working on his switch

Thanks

 

[thesjaakspoiler]

The D+ and D- lines are on the opposite side of the PCB so I don't think that that the issue is related to those missing components.
Besides a filter, they go straight into the BM92T36.

The components all seem to be related to the MAX77620 chip which is used as a charge controller.
https://www.tronicsfixforum.com/upl...50b0c129da91f3a1611ec1151664658204217c3a.jpeg
I couldn't find better close ups so I don't know the values.
In case you really can't find the part numbers, you could try to use the same diode that is used nearby.
I also couldn't find a datasheet for the MAX77620. Maybe there is a reference design in there.