Consistent 2168-0002 error when installing/running Goldleaf and Tinfoil

[Belstone]

Hi All. I've just successfully installed a Hwfly (likely a clone) modchip into my v1 Switch. I've been following the video What after SWITCH Modchip Installation HWFLY - Guide [2022] to set up the software and SD card, I've and gotten up to 4:57 where Goldleaf is to be installed. However, I'm consistently getting error 2168-0002 for Goldleaf and 2168-0001 for Tinfoil. I have tried launching both from the Album and by holding down R to run in Full-RAM mode- neither approach worked with the former getting the 2168-0002 error and the latter resulting in a 'software was closed because an error occurred' message.

I'm using the latest versions of everything (Hekate, Atmosphere, Sigpatches, Goldlead, Tinfoil, etc.) but I cannot figure out how to solve this. OFW is 14.1.2. I'm using a 256GB SD card, if that makes any difference. and I'm using Hekate to launch Atmosphere. I have already tried reinstalling everything from scratch but without success.

Can someone please help me with this? What am I doing wrong? Is there a better current setup guide?

 

[pinbi7]

Hi All. I've just successfully installed a Hwfly (likely a clone) modchip into my v1 Switch. I've been following the video What after SWITCH Modchip Installation HWFLY - Guide [2022] to set up the software and SD card, I've and gotten up to 4:57 where Goldleaf is to be installed. However, I'm consistently getting error 2168-0002 for Goldleaf and 2168-0001 for Tinfoil. I have tried launching both from the Album and by holding down R to run in Full-RAM mode- neither approach worked with the former getting the 2168-0002 error and the latter resulting in a 'software was closed because an error occurred' message.

I'm using the latest versions of everything (Hekate, Atmosphere, Sigpatches, Goldlead, Tinfoil, etc.) but I cannot figure out how to solve this. OFW is 14.1.2. I'm using a 256GB SD card, if that makes any difference. and I'm using Hekate to launch Atmosphere. I have already tried reinstalling everything from scratch but without success.

Can someone please help me with this? What am I doing wrong? Is there a better current setup guide?

turn off your sys-modules and try again

 

[Belstone]

turn off your sys-modules and try again

How do I do that? Could you please explain a bit about what the sys-modules are and do?

 

[pinbi7]

How do I do that?

Delete your contents folder.
then reinstall atmosphere

 

[impeeza]

reinstall atmosphère and sigpatches, and read a real guide, the videos always are outdated.

https://rentry.org/SwitchHackingIsEasy

 

[impeeza]

and do not forget delete the SD:\ATMOSPHERE\contents folder then install new atmosphere and sigpatches.

 

[Belstone]

and do not forget delete the SD:\ATMOSPHERE\contents folder then install new atmosphere and sigpatches.

Thanks. Is this for updating Atmosphere or even if installing for the first time? I'm trying again from scratch with a guide from your suggestions.

 

[pinbi7]

also if you it helps,if you find the solution leave a like and post your findings(it might help others)

 

[Belstone]

OK! It looks like it's working now.

Impeeza was right- use a different guide. I started from scratch again and went through the following guides in this order:

1. Backup the NAND before installing anything
2. Set up Atmosphere with EmuNAND on Erista (SX Core / HWFLY)
3. Install GoldLeaf
4. Install Tinfoil the same way using the self installer

Thanks for your help guys!