checking hwfly cable pinout for v2 switch after failed install killed switch

[vertig0_]

any way I can check using a multimeter if the cable's still good? I see there's a fray on the bottom left ground plane connection. this is after I killed my v2 switch for reasons unknown when trying to install the mod.
Thanks!

Post automatically merged: Nov 28, 2022

well from another thread [sx-core-pcb-leaked.591580] (I cant post links yet) looks like theres no trace running down there. But would still appreciate if anyone could give instructions on how to test the entirety of the part with a multimeter

 

[binkinator]

any way I can check using a multimeter if the cable's still good? I see there's a fray on the bottom left ground plane connection. this is after I killed my v2 switch for reasons unknown when trying to install the mod.
Thanks! View attachment 340440

Post automatically merged: Nov 28, 2022

well from another thread [sx-core-pcb-leaked.591580] (I cant post links yet) looks like theres no trace running down there. But would still appreciate if anyone could give instructions on how to test the entirety of the part with a multimeter

Flip it over and you will see exposed “fingers” at the end marked “up”. You will be able to see traces that you can follow to the 4 solder points marked sp1 and sp2. Trace the fingers to the so points with a multimeter set to check continuity. That should do it. (Really tough for this piece to break tbh.)

 

[vertig0_]

Flip it over and you will see exposed “fingers” at the end marked “up”. You will be able to see traces that you can follow to the 4 solder points marked sp1 and sp2. Trace the fingers to the so points with a multimeter set to check continuity. That should do it. (Really tough for this piece to break tbh.)

YES! I followed the pin using the image of the cable with the masking removed and checked each pad and fingers for continuity. I installed the modchip to a new working switch and loaded into cfw successfully

 

[dehydrated_lemur]

:this comment can be deleted due to double post. Sorry:

 

[binkinator]

on my console, V2 SP1 and SP2 have continuity together. Some other capacitors around this chip appear to be shorted together as both sides of the caps are ground. My multimeter beeps. Is this normal? I haven't soldered anything here and was just replacing thermal paste.

Please don’t double post: https://gbatemp.net/threads/nvidia-chip-capacitors.625357/

Besides, this thread is unrelated.