Recent content by jkyoho

  1. jkyoho

    Picofly AIO Thread

    what firmware on the chip? try higher resistance on dat0
  2. jkyoho

    Edm-020 components values

    so you have short to ground on those area?
  3. jkyoho

    Edm-020 components values

    you mean short from one side to other side or you mean short to ground? Those are inductor/coil, they have low resistance when you measuring one side to the other side, like a 0hm resistor
  4. jkyoho

    Picofly AIO Thread

    I have a v1 APU laying around, if you would sell me some
  5. jkyoho

    Hardware I'm looking for these capacitors for the Switch OLED

    If that was from datasheet/picture made by Big N I wont question, but that's just one picture from online, I wouldnt trust fully but try to measure some myself or find datasheet from the actual chipset. Learning curve varies between people, the more you practice the more you learn. For example...
  6. jkyoho

    Hardware I'm looking for these capacitors for the Switch OLED

    https://www.analog.com/en/products/max77801.html most time you see doesn't mean the truth.
  7. jkyoho

    Is there a certain Tape for nintendo switch screen to frame.

    digitizer is just plastic not glass, any good tape should be OK
  8. jkyoho

    Broken SD card slot?

    more like sd card connector loose pins
  9. jkyoho

    Does this thing really block the Nintendo servers.

    run 90dns tester to make sure they work
  10. jkyoho

    ps5 power regulator ssd

    I have 95-ish ohm to ground on that top right 0.8v ssd controller line from a known good donor EDM-010
  11. jkyoho

    Hacking Hardware Picofly - a HWFLY switch modchip

    close down the long cable flip connection
  12. jkyoho

    Picofly AIO Thread

    That indicates successful glitched. You should close the long extension cable flip before you do anything
  13. jkyoho

    is there any app which can extract prodinfo via payload?

    emmc programmer can dump boot0, boot1 and rawnand.bin. and prodinfo in sinde rawnand not boot0/1 Not sure if prodinfo can be dump separately or not, will try later myself 1716561797 updates: You actually can use NxnandManager with the emmc reader/programmer in Windows so that you could dump...
  14. jkyoho

    is there any app which can extract prodinfo via payload?

    eMMC programmer might be your last hope
  15. jkyoho

    is there any app which can extract prodinfo via payload?

    Hekate(usb_tool-->eMMC RAW gpp mount) + NxNandManager
See more
General chit-chat
Help Users
    Xdqwerty @ Xdqwerty: @BigOnYa, it was maybe funny the third or fourth time companies did it +1