I think that vol+\- should instruct PicoFly FW to skip the glitch and boot to ofw so in this case as you said probably"poor soldering\reflowing\reballing"
If it glitches then it's up to Hekate
Might be wrong though.
Hi, i copied lockpick.bin in payload folder and lockpick.nro in switch folder, trough the payloads menu in hekate i lanched lockpick_RCM.bin and the screen it gone black and dont work anything to boot it up, i press longed power button even 1...
1. Bridge 2 middle pins and you will have 2 pins left on each side and run wire from the 2 bridged pins to the cpu point on pico
2. Yes solder like normal
3. Both pins connect so can use 1 or both same time on cmd, clk, dat
I think that vol+\- should instruct PicoFly FW to skip the glitch and boot to ofw so in this case as you said probably"poor soldering\reflowing\reballing"
If it glitches then it's up to Hekate
Might be wrong though.
1. Bridge 2 middle pins and you will have 2 pins left on each side and run wire from the 2 bridged pins to the cpu point on pico
2. Yes solder like normal
3. Both pins connect so can use 1 or both same time on cmd, clk, dat
Heyo. Been having an issue with the program lately.
Every time I've been trying to save some changes, the program hangs and eventually crashes. I have zero idea what is causing this.
I am on the latest version of the program as well (1.4.6.1)...
thank u for your answer
i have same question please :
1 : ON THE FLEX cable there are 6 pin do i need solder pin 3 and 4 together to the cpu rp2040 ?
2 : do i need solder the v2 flex cable like normal solder same as hwfly on APU ?
3 : do...
thank u for your answer
i have same question please :
1 : ON THE FLEX cable there are 6 pin do i need solder pin 3 and 4 together to the cpu rp2040 ?
2 : do i need solder the v2 flex cable like normal solder same as hwfly on APU ?
3 : do...