i am dumping my latest jtag-nominee and have run into major problems.
First being one of my lpt solder spots is the shonkiest solder job ever, and is barely stuck to the board... it works however... so i am going through all of this VERY carefully.
Secondly, the dumps i am getting thus far (only 1 and 1/2 done atm) getting 2 bad blocks (250 error) at 94 and 1C0. (both bad at these same points)
just want to know if this will cause an issue when i try to install freeboot? i know there are work arounds for bad blocks, but im not sure as uve never had to do any myself, so knowledgable people, such as yourselves, may be able to help me.
Thirdly, is there an updated dump procedure i should follow that is foolproof?
some guides recommend the full 16mb dump, some say a partial dump will do... i always do the full 16mb just in case... but whats the best way? I personally havnt done this sort of thing since XBR3, and have not jtag'd straight to freeboot.
thanks all
First being one of my lpt solder spots is the shonkiest solder job ever, and is barely stuck to the board... it works however... so i am going through all of this VERY carefully.
Secondly, the dumps i am getting thus far (only 1 and 1/2 done atm) getting 2 bad blocks (250 error) at 94 and 1C0. (both bad at these same points)
just want to know if this will cause an issue when i try to install freeboot? i know there are work arounds for bad blocks, but im not sure as uve never had to do any myself, so knowledgable people, such as yourselves, may be able to help me.
Thirdly, is there an updated dump procedure i should follow that is foolproof?
some guides recommend the full 16mb dump, some say a partial dump will do... i always do the full 16mb just in case... but whats the best way? I personally havnt done this sort of thing since XBR3, and have not jtag'd straight to freeboot.
thanks all