What more detail is there? What could of caused this? Xecuter boots up. Works fine, can add autorcm if I wanted to. Etc. But once I boot up the cfw. Nintendo logo loads then Nintendo switch logo shows up but it stays stuck on Nintendo switchWith such little details, your guess is as good as ours.
What more detail is there? What could of caused this? Xecuter boots up. Works fine, can add autorcm if I wanted to. Etc. But once I boot up the cfw. Nintendo logo loads then Nintendo switch logo shows up but it stays stuck on Nintendo switch
Same results. Normal firmware works. I got a 2nd Switch and it boots up Xecuter normally. I don't want to figure out why it doesn't work on my first one though. I don't want to switch(actual word) the sd cards cause the console deleted files when you put an sd card that was from another switchAre you booting directly into the CFW settings each time by holding volume up after letting go of power? If so try lettings go of both power and volume up after 2 seconds to boot directly into CFW. See what happens.
I actually did downloaded some themes and they never showed up. When I saw that the themes didn't work I just ignored it. I downloaded themes off the homebrew shopIf you format your sd card and try the process from the beginning, it should work. If it doesn't, your sd card is probably broken.
I imagine you were using themes or something and you need to delete some of the titles directories to get it working again.
Remove the: /sxos/titles/0100000000001000/ folder.
Don't blame SXOS - for you installing modded themes - this error is on you an nobody else, take responsibility for your own actions.