Will any tinning flux not work when hardmoding a 2ds?

Discussion in '3DS - Console, Accessories and Hardware' started by Stevedavid678, Nov 18, 2016.

  1. Stevedavid678
    OP

    Stevedavid678 Member

    Newcomer
    1
    Feb 1, 2016
    United States
    I need to hardmod my 2ds to unbrick it but when I was buying the parts I did not know which tinning flux to get for it. Is this one from ebay good? "Tinning Flux 1.7oz W/O Brush,No 30374, Oatey Company"
     
  2. Hazelnutz

    Hazelnutz Member

    Newcomer
    1
    Dec 1, 2015
    Sydney
    any flux will do
    i use this one Flux
     
  3. Stevedavid678
    OP

    Stevedavid678 Member

    Newcomer
    1
    Feb 1, 2016
    United States
    Thank you so much! :)
     
  4. Hazelnutz

    Hazelnutz Member

    Newcomer
    1
    Dec 1, 2015
    Sydney
    np you don't need to use too much, gets messy on boards if you put too much.
     
  5. Stevedavid678
    OP

    Stevedavid678 Member

    Newcomer
    1
    Feb 1, 2016
    United States
    Thank you for your tips.:yay3ds:
     
  6. Stevedavid678
    OP

    Stevedavid678 Member

    Newcomer
    1
    Feb 1, 2016
    United States
    The one I mentioned above says its not for electronics.
    Will it still work?
     
  7. Hazelnutz

    Hazelnutz Member

    Newcomer
    1
    Dec 1, 2015
    Sydney
    the one you linked its for soldering pipes which plumbers use with a blow torch.

    just buy the one i linked to you
     
    zoogie likes this.
  8. Stevedavid678
    OP

    Stevedavid678 Member

    Newcomer
    1
    Feb 1, 2016
    United States
    Thankyou again. :D
     
Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice