WiiKey Long Wire Installation Question

Discussion in 'Wii - Hacking' started by Alerek, Feb 7, 2008.

Feb 7, 2008
  1. Alerek
    OP

    Member Alerek GBAtemp Fan

    Joined:
    Jan 25, 2008
    Messages:
    317
    Location:
    Midwest
    Country:
    United States
    About to install a WiiKey via the long wire method, just curious as to where I should physically place the chip after it is finished. I read somewhere about using electrical tape to attach it to something, just not too sure. I don't want to place it somewhere & have it interfere or overheat.
     
  2. rightguardsport

    Newcomer rightguardsport Advanced Member

    Joined:
    Jan 30, 2008
    Messages:
    60
    Country:
    United States
  3. Alerek
    OP

    Member Alerek GBAtemp Fan

    Joined:
    Jan 25, 2008
    Messages:
    317
    Location:
    Midwest
    Country:
    United States
    Thank you for that link, and thank you for keeping me not so smelly [​IMG]


    Ehh, like a nerd like myself wears deoderant that has "Sport" In the name XD
     
  4. rightguardsport

    Newcomer rightguardsport Advanced Member

    Joined:
    Jan 30, 2008
    Messages:
    60
    Country:
    United States
    Took me a while to figure that out [​IMG]
     
  5. skullwolf

    Newcomer skullwolf Member

    Joined:
    Jan 30, 2008
    Messages:
    16
    Country:
    United States
    What I did was secure mine down with electrical tape in a little gutter to the side.

    [​IMG]

    See the little area in the black plastic to the right of the highlighted install area? The wiikey will fit there and not get in your way. I made the wires go through the upper right hand corner of the install area, between those two sockets.

    Almost no chance of overheating there.
     

Share This Page