Wii mote wont sync

Discussion in 'Wii - Hacking' started by Leussink, Sep 4, 2010.

  1. Leussink
    OP

    Leussink Advanced Member

    Newcomer
    80
    0
    Apr 17, 2009
    Netherlands
    Hello,

    I got a wii with 4,2.
    Bootmii was installed on it and wenn bootmii loads it goes to wiiflow.
    Today i go to a friend and used my wii motes.
    Now i cant sync my motes.
    I try to go to the homebrewchannel but it wont load.
    I try to load a dol with bootmii wont work.
    In wii flow i cant go to the system menu because my wii motes wont load.

    What should i do????

    Helps a nand restore?
     
  2. mike333

    mike333 GBAtemp Advanced Fan

    Member
    708
    61
    Aug 30, 2010
    Poland
    Do You tried wiimote synchronization method described in wii manual?
     
  3. Leussink
    OP

    Leussink Advanced Member

    Newcomer
    80
    0
    Apr 17, 2009
    Netherlands
    Yes i tried to hit both 2 red buttons the same time
     
  4. mike333

    mike333 GBAtemp Advanced Fan

    Member
    708
    61
    Aug 30, 2010
    Poland
    Set bootmii to launch system menu and retry there.
     
  5. FIX94

    FIX94 Global Moderator

    Global Moderator
    7,210
    9,282
    Dec 3, 2009
    Germany
    ???
    Hold the red button on your wii 30 seconds down, restart the wii, press the red button on your wii and 3 seconds later press the red button on your wiimote.
     
  6. JonthanD

    JonthanD GBAtemp Regular

    Member
    279
    0
    Jul 9, 2010
    United States
    Sitting
    I have 2 Wii's and when I use the extra controls for one (4 players) I have the same thing happen all the time.... Best advice is to pull the batteries, put them back in, press the red sync on the Wii then the Red button on the Wiimote... It may take a few tries [​IMG]

    Also power on your Wii with the Wiimote your trying to resync IF that works for some reason its a lot easier to get them to sync.


    Edit: Also the post above me sounds about right (its probably one of the things I do when swapping remotes in and out.
     
  7. Leussink
    OP

    Leussink Advanced Member

    Newcomer
    80
    0
    Apr 17, 2009
    Netherlands
    Thanks in advance. It works for me!
    I did it in bootmii and after pressing the reset button it goes to preloader.
    Then i use my gamecube controller to go to the system menu and then i fixed it.

    Normal i go in bootmii to my homebrew channel, use my cube controller but the homebrew channel wont load.

    But thanks for all [​IMG]