which chip to use

Discussion in 'Wii - Hardware, Devices and Utilities' started by df78, Jul 9, 2008.

Jul 9, 2008

which chip to use by df78 at 7:48 AM (1,678 Views / 0 Likes) 6 replies

  1. df78
    OP

    Newcomer df78 Member

    Joined:
    Jun 20, 2006
    Messages:
    10
    Country:
    I ran the wii tracker and i got the following message:-

    There is a 50% chance that your drive chip is a GC2-D2C

    There is a 50% chance that the pins on your drive chip are not cut.

    my wii starts with LU56**** series. which modchip will work for me? by the way, is foundmy the cheapest place to get mod chips? any other recommendations?

    What does it mean that the drive chip are not cut?

    Thanks!
     
  2. linuxares

    Member linuxares GBAtemp Maniac

    Joined:
    Aug 5, 2007
    Messages:
    1,384
    Country:
    Sweden
    Wasabi or D2Pro, go with Wasabi if you can since D2Pro is a ***** to update.


    EDIT: Depends where you live, D2C are NEVER cut, so no worries about that.
     
  3. pokemongalaxy

    Banned pokemongalaxy Banned

    Joined:
    Mar 10, 2008
    Messages:
    717
    Country:
    Canada
    I suggest wasabi since it works on all drives, and yours could %50 be d2c.
    I got my chip from techsick, though I got the solderless d2ckey
     
  4. df78
    OP

    Newcomer df78 Member

    Joined:
    Jun 20, 2006
    Messages:
    10
    Country:
    hi peeps, thanks for the fast response. so d2prov9 is out? i would be safe with just wasabi right?

    thanks!
     
  5. pokemongalaxy

    Banned pokemongalaxy Banned

    Joined:
    Mar 10, 2008
    Messages:
    717
    Country:
    Canada
    yes wasabi definitely
     
  6. Aricado

    Newcomer Aricado Member

    Joined:
    Aug 9, 2007
    Messages:
    12
    Location:
    Under your bed xD
    Country:
    Greece
    Better make an OpenWii one.
    They are the best in my opinion.
    Compatible with all drives,fast updates etc etc.
    It cost me around 3euros to make it and 2 euros
    to make the programmer.
     
  7. df78
    OP

    Newcomer df78 Member

    Joined:
    Jun 20, 2006
    Messages:
    10
    Country:
    ok. so shall i update my wii first before i put in the chip or can the updating be done after?

    i intend to use wii clip, but should i ask them to solder it assuming it's a d2c or do i leave it unsoldered?

    which soldering tools do u guys recommend?

    thanks!
     

Share This Page