To my understanding the safe limits are 1963, 998 and 1996 MHz but I don't know if this applies to docked or handheld mode. In docked mode there is less power draw because the Switch does not need to power the screen. Do we need slightly lower overclock values in handheld mode?
What are the safe overclock limits for Mariko in handheld mode?
- Thread starter ragnarok_approaches123
- Start date
- Views 1,450
- Replies 1
Similar threads
- Poll
-
-
@
SylverReZ:
If you want a good system to port it to, at least have a good programmer and knowledge.+1 -
-
-
-
@
Psionic Roshambo:
I didn't know they made an MSU cart for the Genesis.... I knew about the SNES one and the library for that is rather large but the Genesis one has very few games+1
-
-
@
SylverReZ:
An FPGA could probably replicate the chip's functionality without buying donor parts.+1
-
-
-
@
Psionic Roshambo:
Like not emulating the entire SNES but just a loader and the enhancement chips perhaps even slightly overclocked like FX-2
-
-
-
-
-
-
-
@
SylverReZ:
@Psionic Roshambo, The Doom NES cartridges, a few batches were made. One was given to AVGN as seen in his Doom video.+1
-
-
@
Sicklyboy:
I finally modeled and 3d printed the new HDD cages I need in order to build my 2nd NAS. Original ones don't fit the mounting holes on the hdds I'm using. Been sitting on this project for over 2 years smfh -
-
@
Sicklyboy:
I'm finally gonna get this NAS racked and powered on tonight, install truenas core, and burn the disks in with badblocks
-
@
Sicklyboy:
Also another 70TB going in the front mount drive bays of this server. 182tb raw, going to probably use a zfs RAID-Z3 for 3 parity disks, so 140TB usable
-
@
Sicklyboy:
I could claw back 14tb by only doing 2 parity disks but I feel like with 13 disks in the RAID I'd be kind of pushing my luck on rebuild time if I encounter a disk failure
-
