Switch V2 picofly works a while then stuck on logo ofw and after atmopshere logo

[longson008]

Have a switch v2 worked perfectly for a while.

Then it stopped working.
Picofly chip do works and can go to Hekate.
Can make backup and no errors
Cannot emummc because slower mode hardware issue.
Cannot blot ofw via Hekate upstart.

Help.

Longson

 

[longson008]

Installed flex and no more slow mode and could make emummc. Can't start ofw stuck on switch logo and cfw stuck after atmopshere logo. Please help

 

[Donnie-Burger]

Installed flex and no more slow mode and could make emummc. Can't start ofw stuck on switch logo and cfw stuck after atmopshere logo. Please help

Try a legit micro.

 

[longson008]

Try a legit micro.

It's a legit Samsung sd micro. Tri d now and restoration. Could run all restore steps on emunand but not on sysnand. Comes to the point where emunand cfw seems to running fine but cannot read the atmopshere files because after wipe it requires system update to be able to run bigger sd cards

Post automatically merged: Jun 14, 2023

Solved it by followed the right guide for restore nand. Have to move the files to restore before restore in Hekate. Problem from the beginning was wifi chip faulty. Lost wifi after started up the switch. Reheated the switch wifi chip.
Now it works and after system update all error was gone. Hope somebody find this helpful

Longson