So I've been using my modded V2 mariko switch with a hwfly chip, that has the sx firmware on it. When the other day it Suddenly won't read any SD cards anymore when booting. I've tried several to no avail.
So I've ordered a new sd card reader, and while waiting for it, it would boot again to Hekate and into cfw without any issues. I could reboot my switch without any issues for a couple of days, even play for hours without issues, and now it does the same thing.
After replacing the reader, the issue is still the same, so I'm really confused what it going on.
I don't think the chip is the issue, as my switch boots to the boot.dat error screen fine.
The connector port is looking perfectly fine. Is there anything else I can take a look at?
So I've ordered a new sd card reader, and while waiting for it, it would boot again to Hekate and into cfw without any issues. I could reboot my switch without any issues for a couple of days, even play for hours without issues, and now it does the same thing.
After replacing the reader, the issue is still the same, so I'm really confused what it going on.
I don't think the chip is the issue, as my switch boots to the boot.dat error screen fine.
The connector port is looking perfectly fine. Is there anything else I can take a look at?
Last edited by Rekna,