Hello. I modded an OLED with the Instinct V6 chip (based on HWfly). I was getting some issues that led me to believe I need to replace the capacitors, and did so, but a pad was unfortunately removed for SP1. I decided to just take the caps off after I was having issues. I was getting a flashing yellow light after purple blinking. I then went into fix my DAT0 connection, as well as to fix any connection at the CPU that might have been there.
After that I get a white then purple then white flashing light. I was checking my diode voltages and everything looked right. I then removed the modchip just to make sure it still turned on, and it did not. There is 15V power, and only 200mA of current draw with the battery plugged in. I proceeded to check for any shorts everywhere, but could not find one anywhere.
I have no idea what happened. One second it was fine, the other it was bad. I did happen to unplug the battery in the middle of training/turning on. Could that have caused any of these issues? Thanks for any advice.
Thanks,
After that I get a white then purple then white flashing light. I was checking my diode voltages and everything looked right. I then removed the modchip just to make sure it still turned on, and it did not. There is 15V power, and only 200mA of current draw with the battery plugged in. I proceeded to check for any shorts everywhere, but could not find one anywhere.
I have no idea what happened. One second it was fine, the other it was bad. I did happen to unplug the battery in the middle of training/turning on. Could that have caused any of these issues? Thanks for any advice.
Thanks,
