Hacking Question Switch gets stuck in Nintendo logo when trying to boot anything on sysNAND after nand backup restore

[MMangia]

Hi, I recently restored a nand backup (9.2.0) on my switch and after the Nintendo logo it gets stuck.
I can access RCM and the CFW on emuNAND works fine, but I can't access the OFW on sysNAND.
No, I didn't downgraded it, it was the same version.

 

[thesjaakspoiler]

It used to happen when the number of burnt fuses is higher than expected.
Are you sure you restored a 9.2.0 backup and not an older one?

 

[MMangia]

It used to happen when the number of burnt fuses is higher than expected.
Are you sure you restored a 9.2.0 backup and not an older one?

Yes, i'm 100% sure

 

[Khar00f]

Yes, i'm 100% sure

Did you try restoring Boot0/1 as well?

If not, I would disable AutoRCM, restore boot0/1 and then try booting into OFW.

Also a little context as to what happened might help us assist you better, If you were on 9.2 what happened that caused you to want to restore 9.2?

Also which steps did you undertake to restore your nand?

Any additional information helps,