I got a black shock case for my ds, the problem is that i gooffed somehow, i flip the power switch and the bottom screen justs flickers, did i connect the ribbon wrong or what, and can you guys give me some tips on how to put the ribbon in, i was barely able to snap down on the clamp last time.
- Joined
- Jul 17, 2003
- Messages
- 1,056
- Trophies
- 0
- Age
- 58
- Location
- left of the pond
- Website
- Visit site
- XP
- 405
- Country
chances are that the ribbon cable for the lower lcd screen is not plugged all the way and is not inserted properly (eg. straight). I had this problem when I re-assembled mine. (the system would turn on for a brief moment, and the bottom screen would flash before shutting itself down again).
make sure that both sides of the ribbon cable are inserted the same amount as well as it being inserted as far as it will go before locking down the clip.
make sure that both sides of the ribbon cable are inserted the same amount as well as it being inserted as far as it will go before locking down the clip.
Similar threads
-
-
-
-
-
-
-
-
-
-
-
@
SylverReZ:
If you want a good system to port it to, at least have a good programmer and knowledge.+1 -
-
-
-
@
Psionic Roshambo:
I didn't know they made an MSU cart for the Genesis.... I knew about the SNES one and the library for that is rather large but the Genesis one has very few games+1
-
-
@
SylverReZ:
An FPGA could probably replicate the chip's functionality without buying donor parts.+1
-
-
-
@
Psionic Roshambo:
Like not emulating the entire SNES but just a loader and the enhancement chips perhaps even slightly overclocked like FX-2
-
-
-
-
-