Save saver...

Discussion in 'Supercard' started by ojsinnerz., Mar 20, 2008.

Mar 20, 2008

Save saver... by ojsinnerz. at 8:59 PM (961 Views / 0 Likes) 2 replies

  1. ojsinnerz.
    OP

    Member ojsinnerz. Damned

    Joined:
    Oct 27, 2007
    Messages:
    3,152
    Location:
    Canada
    Country:
    Canada
    Ok, after I've put a bit of homebrews onto my micro sdhc, I've put it in the SC DS1 SDHC. When it loads, it says "Save saver, please wait" About 16-20 minutes later, it's still the same.

    Any suggestions of what to do?
     
  2. xcalibur

    Member xcalibur Gbatemp's Chocolate Bear

    Joined:
    Jun 2, 2007
    Messages:
    3,166
    Location:
    Sacred Heart
    Country:
    United Kingdom
    Is the actual hardware of your DS fine?
    I had a faulty touchscreen which always thought I was putting pressure on a certain point so it wouldn't let me get past that screen either.

    Press L+R on startup of the DS to go into selfexamining mode. If its fine it might be a hardware error.
    You could also go on the microSD and remove everything except scshell and msforsc.nds on the card and see if it does the same thing.
     
  3. ojsinnerz.
    OP

    Member ojsinnerz. Damned

    Joined:
    Oct 27, 2007
    Messages:
    3,152
    Location:
    Canada
    Country:
    Canada
    Thx, but everything on the card is fine, or so it says on the test... Same thing with the Erasing everything but the scshell...

    I've actually tested if the DS is fine, with a genuine Zelda PH, and it worked fine.

    I'll back up, then format the card, just to see how it goes...

    EDIT:Ok, it works.
     

Share This Page