Restore nand created with GW results in bootrom 8046?

Discussion in '3DS - Flashcards & Custom Firmwares' started by Mach III, Nov 4, 2014.

  1. Mach III
    OP

    Mach III Newbie

    Newcomer
    5
    1
    Oct 5, 2010
    Norway
    My 3ds xl fw 4.1 was accidentally updated to 6.0. I have now soldered the 4 wires to the mb for downgrading, but each time I send the nand saved with GW I always get blue screen with bootrom 8046 error,
    even tho win32diskimager says successfully writing. What am I missing?

    Mach III
     
  2. Adr990

    Adr990 To boldly go where no man has gone before!

    Member
    1,470
    146
    Apr 22, 2007
    Netherlands
    The Netherlands
    After the HW mod installation, before you restored your NAND, could you turn on the 3DS normally?

    Otherwise, check your wiring, make sure they aren't too long.
    Or wait a little, and try booting the 3DS later again.

    I hope you've made a backup of your 6.0 NAND too? Try to restore that one otherwise. Maybe your 4.1 dump was bad.
     
    Subtle Demise likes this.
  3. Mach III
    OP

    Mach III Newbie

    Newcomer
    5
    1
    Oct 5, 2010
    Norway
    Yes, it started as it should after the soldering, no problem.
    Will try to make the wires a little bit shorter and flash again.
    Stupid me did not take backup of 6.0, so I'll guess I'm doomed if it's a bad dump.:(
     
    Subtle Demise likes this.