PS1/2 [PS2] Issues with M1 SkyShare A5-V11 3G Router for OPL

[nitorinitori]

I tried to set up the router according most YouTube tutorials by going to the admin panel, set the port triggering thingy, and enable file sharing. and on PS2 OPL, set to DHCP, SMB IP to 192.168.100.1, username and password leave as "admin" and share "media".

I couldn't get it work when I plug the LAN cable to my PS2 Slim SCPH70000. As for the power source, I plugged it to dedicated 12W phone charger.

When I plug my FAT32 USB Drive and LAN cable to my PS2, it starts flashing blue, blue red, red, and repeat. While it doing that, I tried to "Reconnect" my OPL and the OPL says "Unable to connect to SMB server"

But when I remove the USB Drive, it starts to flash only blue lights on and off.

The worst thing is that when I unplug the router to the power source and plugged it back, it stops responding and only shows red and blue light forever. When it does this, I could not discover the WiFi on my phone. Also OPL says "No internet connection". It will keep doing this for hours even if you replugged it. You'd have to leave it for 2-3 hours or so and it will back to normal.

Anyone knows how to get this router setup for OPL ?

Thanks in advance.

 

[Fien]

I recommend to try using a PC to connect to it first and be sure the SMB share works before trying with the PS2.

 

[nitorinitori]

I recommend to try using a PC to connect to it first and be sure the SMB share works before trying with the PS2.

thanks for the reply.
how to test the SMB share ?

i tried to connect it to PC thru LAN, sometimes I'd get it working sometimes it won't work. and most of the times, if i unplug the power, i'd have to wait for 2-3 hours until i can try again, because it would just show blue and red light and does nothing. i don't know if my unit's faulty.

 

[adam_483]

thanks for the reply.
how to test the SMB share ?

i tried to connect it to PC thru LAN, sometimes I'd get it working sometimes it won't work. and most of the times, if i unplug the power, i'd have to wait for 2-3 hours until i can try again, because it would just show blue and red light and does nothing. i don't know if my unit's faults

Hi. Did you solve it? I have the same problem, error "300"

 

[esmith13]

I am not familiar with this router but If it's set up to use the ethernet as a local LAN port then it's WiFi should be in an internet uplink mode not a client/access point mode and therefore only be able to connect to your home router, not a phone or PC client. How this works varies by product but for these tiny pocket routers with wifi and one LAN port one is IN and the other is OUT and you can switch modes to get the physical setup you need.

I'm guessing your ethernet post is expecting to be plugged to your router not you PS2 (client) and the WiFi is expecting to talk to the client not the router.

Hope that makes sense.