Problem with my G6 Lite

Discussion in 'Other Flashing Hardware & Software' started by n3rd, Apr 19, 2007.

Apr 19, 2007

Problem with my G6 Lite by n3rd at 12:37 AM (755 Views / 0 Likes) 3 replies

  1. n3rd
    OP

    Newcomer n3rd Member

    Joined:
    Mar 13, 2007
    Messages:
    33
    Country:
    Belgium
    Hi all,

    I have put my G6 Lite into the standard GBA card and it seem to don't fit correctly cause The Card is not detected by the Uburner
    Anyone Have the same problem or is just my GBA cart ???

    Thx
     
  2. Destructobot

    Member Destructobot Crave the Hammer

    Joined:
    Oct 15, 2006
    Messages:
    5,005
    Location:
    Portland, OR
    Country:
    United States
    Does it work in the Lite shell?
     
  3. jalaneme

    Member jalaneme Female Gamer

    Joined:
    Nov 27, 2006
    Messages:
    6,247
    Location:
    London
    Country:
    United Kingdom
    make sure the screw is tight not loose, and if the side of the casing has a gap, tape it down, also make sure the circuit board is aligned properly inside the gba casing.
     
  4. n3rd
    OP

    Newcomer n3rd Member

    Joined:
    Mar 13, 2007
    Messages:
    33
    Country:
    Belgium
    not sure to understand it all

    I have screwed it well


    Put the pcb with the little hole but it still moving in my GBA card

    Im not using the lite cause I don't use G6 for my ds but for my GBA (for my ds I have a M3symply)
     

Share This Page