Hey guys.
I bought this kit from ebay so that I could flash my new BenQ drive.
Following Textbook's guide from 360mods.net, I installed the card etc. hooked up my 360, created a bootable usb pen drive with iprep, took out all my HDs and burners etc. afaik everythin was ready to go.
So I reboot my PC, it boots the usb pen drive and I get as far as this screen:
I hit Y and instantly I get a code, 0x7F. No matter how many times I turn on and off the 360 this doesn't change (it should go between 0x51 and 0xD1).
It's as though it's not picking up my BenQ at all. I also got the MTK Vendor Intro Failed On Port 0xDC00 but I think thats standard as it's in the screen I posted above, taken directly from the guide.
Only thing I can think of that I may be doing wrong is I used the sata port on the back of the pci card, back of my pc. I just read it's best to use the internal port, one closest to the front of the pc. Another thing I noticed is it says not to install the RAID tools with hardware wizard when installing the pci sata card. Not sure whether I have or not.
Any help/advice much appreciated. So close, yet so far
I bought this kit from ebay so that I could flash my new BenQ drive.
Following Textbook's guide from 360mods.net, I installed the card etc. hooked up my 360, created a bootable usb pen drive with iprep, took out all my HDs and burners etc. afaik everythin was ready to go.
So I reboot my PC, it boots the usb pen drive and I get as far as this screen:
I hit Y and instantly I get a code, 0x7F. No matter how many times I turn on and off the 360 this doesn't change (it should go between 0x51 and 0xD1).
It's as though it's not picking up my BenQ at all. I also got the MTK Vendor Intro Failed On Port 0xDC00 but I think thats standard as it's in the screen I posted above, taken directly from the guide.
Only thing I can think of that I may be doing wrong is I used the sata port on the back of the pci card, back of my pc. I just read it's best to use the internal port, one closest to the front of the pc. Another thing I noticed is it says not to install the RAID tools with hardware wizard when installing the pci sata card. Not sure whether I have or not.
Any help/advice much appreciated. So close, yet so far