All the screws in my 3ds are fine except one which is like broken i guess? i cant unscrew it for a hardmod!
This happened to me once on one of my older o3ds's. The screw got broken while inside the 3ds and couldn't be unscrewed by any kind of screwdriver.
The only solution the tech found was to melt the plastic VERY CAREFULLY with a solder machine (and of course, breaking permanently that screw slot). But i had to do it for a motherboard switch...
The only solution the tech found was to melt the plastic VERY CAREFULLY with a solder machine (and of course, breaking permanently that screw slot). But i had to do it for a motherboard switch...
If you can't figure out you need to use a drill to remove the screw, you really have no business soldering a hardmod...
Except vb_encryption_vb did mention the drill. the drill trick is usually done with a rubberband between the drill and the stuck screw.
Last thread before this one was created on Sunday, which makes this _slightly_ acceptable.
Just remember @olec04 that I'm watching you
Easiest way is to use a small tip drill. I used a dremel in the past on high settings and the screw head popped off. Just don't put too much downward pressure and just get the inside of the screw head to thin out and it pops off.
Similar threads
- No one is chatting at the moment.
-
@
Psionic Roshambo:
I wonder if I could recommend that to some emulation devs that perhaps the sound could use some smoothing out to simulate those old TVs -
@
Psionic Roshambo:
I think a few of the early systems could benefit from that, at least up to the 8 bit generation, by the 16 bit generation I think TVs had gotten a lot better in almost every way
-
-
-
-
-
-
-
-
-
-
@
Xdqwerty:
it says it only works for the original R4, R4i Gold (r4ids.cn), R4iDSN (r4idsn.com) and Acekard R.P.G. -
-
-
-
-
-
@
Psionic Roshambo:
Just give it a try, but honestly if you have a 3DS you can play DS games without a card just off the internal SD card
-
-
-
-
-
-
-
