Ninjhax 2.7 isn't working on my O3ds 11.0.0-33U console.

Discussion in '3DS - Homebrew Development and Emulators' started by Scarfman, Dec 5, 2016.

  1. Scarfman
    OP

    Scarfman Newbie

    Newcomer
    4
    0
    Dec 5, 2016
    United States
    New York, USA
    Looking for a helping hand; every time I attempt to load Ninjhax 2.7 using the Ninjhax method, my screen stalls on the QR code screen and doesn't do anything until I hit the back arrow. It pings (showing me it identifies it's a QR code) but doesn't load it.

    My knowledge on hacking is limited, so maybe I'm just making rookie mistakes, but I doubt it because I did this before on the same console when it was 9.4.0.

    Any help? Thank you all! I can supply anything needed.
     
  2. LongDongSilver

    LongDongSilver GBAtemp Regular

    Member
    179
    102
    Dec 1, 2016
    United States
    The Buvvins
    you got boot.3dsx on the root of your sdcard i remember getting mad af for a solid hour only to realize that i downloaded the starter kit but didn't transfer it to my card
     
  3. Scarfman
    OP

    Scarfman Newbie

    Newcomer
    4
    0
    Dec 5, 2016
    United States
    New York, USA
    Yep! Here's what's loaded onto my SD card.
    upload_2016-12-5_0-3-1.png
     

    Attached Files:

  4. LongDongSilver

    LongDongSilver GBAtemp Regular

    Member
    179
    102
    Dec 1, 2016
    United States
    The Buvvins
    try this code
     

    Attached Files:

  5. Scarfman
    OP

    Scarfman Newbie

    Newcomer
    4
    0
    Dec 5, 2016
    United States
    New York, USA
    Still does the same thing it's been doing. Here's a visual of what I get, by the way. It'll stay on this screen until the end of time or until I press the back arrow.
    upload_2016-12-5_0-21-21.png
     
  6. LongDongSilver

    LongDongSilver GBAtemp Regular

    Member
    179
    102
    Dec 1, 2016
    United States
    The Buvvins
    clear your save by pressing L+R+X+Y on the main menu and try it again make sure your internet is set up properly
     
  7. Voxel

    Voxel Fable Junkie

    Member
    GBAtemp Patron
    Voxel is a Patron of GBAtemp and is helping us stay independent!

    Our Patreon
    5,208
    5,957
    Jun 27, 2015
    United Kingdom
    England, UK
    From 11.0 onwards, you have to scan more than 1 QR code. There should be 15 QR codes on the Ninjhax page that you should scan in sequence, so just scanning 1 isn't enough:

    upload_2016-12-5_15-29-27.png
     
  8. Scarfman
    OP

    Scarfman Newbie

    Newcomer
    4
    0
    Dec 5, 2016
    United States
    New York, USA
    Thank you so much! This was my problem. I thought just scanning a few would have worked just like 9.4, but apparently not. Thanks again!