My DSi won't read my Acekard 2i unless I hold it down

Discussion in 'Acekard' started by silentdead42, Mar 18, 2010.

  1. silentdead42
    OP

    Newcomer silentdead42 Newbie

    Joined:
    Mar 18, 2010
    Messages:
    1
    Country:
    United States
    My Acekard 2i works in a regular ds but in my DSi won't read it unless I keep it held down a little further in. I'm thinking maybe I could use some glue or something to help it stay down far enough. Just to make sure everyone knows this my Acekard 2i DOES work and has the firmware update needed for (1.4). The only issue is that it doesn't get proper contact for my DSi to read my card. Any ideas or help you can give me is greatly appreciated.
     
  2. Wabsta

    Member Wabsta you fight like a dairy farmer

    Joined:
    Apr 25, 2008
    Messages:
    2,485
    Location:
    SCUMM Bar
    Country:
    Netherlands
    Just put a piece of paper between the cart and then DSi.
     
  3. Dark^'^Knigh

    Member Dark^'^Knigh GBAtemp Maniac

    Joined:
    Apr 25, 2007
    Messages:
    1,043
    Location:
    Paradise
    Country:
    Australia
    Glue ?? ....next thread would be "stuck on loading" [​IMG]

    As wabsta said, just slip a bit of paper between flashcart (sticker side) & inside of the DSi slot.
     

Share This Page