Mother 3 not booting w/ AK2 and 3-in-1

Discussion in 'Acekard' started by slappyX, Apr 21, 2009.

Apr 21, 2009
  1. slappyX
    OP

    Newcomer slappyX Newbie

    Joined:
    Apr 21, 2009
    Messages:
    1
    Country:
    United States
    I just received my ezflash v 3-in-1 in the mail today and I cant seem to get Mother 3 to boot arfter it copies to the NOR flash. It will get to the GBA boot screen, but at the part where it's supposed to show the "fan translation" screen, I get garbled red squares.

    What I'm using:

    DS lite
    Acekard 2.1 with latest AKAIO FW (1.4.1)
    EZFV 3-in-1
    8gb A-Data card
    Mother 3 rom with translation patch

    Any tips on getting this running would be much appreciated.
     
  2. VatoLoco

    Member VatoLoco Don't crush that dwarf, hand me the pliers.

    Joined:
    Jan 29, 2008
    Messages:
    2,261
    Location:
    Ya Cant Get There From Here
    Country:
    United States
    You more than likely have the new 3in1+, which is what i've got and encountered the same problem.
    Use the latest version of Rudolphs GBAexploder to flash Mother3 to NOR then launch it from the DS start-up screen
     
  3. Blake1710

    Member Blake1710 GBAtemp Regular

    Joined:
    Dec 24, 2008
    Messages:
    185
    Location:
    New South Wales, Australia
    Country:
    Australia
    ^ i've got it running from GBA Exploader, although it has been varied results

    best bet, like vato said, is to run through the DS firmware.

    just like running a normal gba game.
     

Share This Page