Micro SDHC card scratching on the back?

Discussion in 'NDS - Flashcarts and Accessories' started by MitchStar, Jul 9, 2008.

Jul 9, 2008
  1. MitchStar
    OP

    Newcomer MitchStar Advanced Member

    Joined:
    Jun 1, 2007
    Messages:
    71
    Country:
    United States
    I have this Kingston 4gig Micro SDHC card:
    http://www.newegg.com/Product/Product.aspx...N82E16820134638

    It came with a usb reader which I must use because my computer does not have a normal SD port. I've noticed when I put it in the reader, its very hard to remove it. if I press down and out, I can move it out just a tiny bit, and then, I can barely grab on to both ends with my nails and pull it out. After doing this, I noticed that the small square sticker on the back is somewhat stratched at the ends where my nails pull it out. Is this normal, and does it hurt the micro SDHC card (or should I just be worried about the gold parts at the other end?)
     
  2. Monster On Strin

    Member Monster On Strin GBAtemp Fan

    Joined:
    Jun 19, 2008
    Messages:
    332
    Location:
    The other side of the internet
    Country:
    United States
    I have the same reader
    it kinda hard to remove it, but not to hard
    I never scratched my sticker
    I don't think it could damage the microsd
    I wouldn't consider it normal
     
  3. Sephi

    Member Sephi fool

    Joined:
    Jan 21, 2008
    Messages:
    1,850
    Location:
    Rhode Island
    Country:
    United States
    Those types of card readers are terrible, I suggest you use a thin flat head screw driver to the to widen the opening slightly, if it still gets stuck you should get a new card reader.
     

Share This Page