Gaming Lite-On 93450c help

cheatmaster5

Well-Known Member
OP
Member
Joined
Feb 19, 2009
Messages
298
Trophies
0
XP
343
Country
United States
I used a xecuter lt switch to dump my firmware, which it did. When I load my firmware it has me enter my serial data which I did, Is that necessary? When I go to flash the drive it writes all the banks fine but when it does verification I get "Write Verify Failed" How do I fix this?

Any help would be great!!
Thanks in advance
 

FAST6191

Techromancer
Editorial Team
Joined
Nov 21, 2005
Messages
33,866
Trophies
2
Website
trastindustries.com
XP
22,598
Country
United Kingdom
Serial data is optional- indeed if you have a full dump from a switch and it does not have it that would indicate it was never necessary.

As for the other problem I assume the switch was removed or reset to such a point that it is not holding the drive in dump firmware mode. If so I am first going to go with did you erase (as in manually erase) the drive beforehand and power cycle it before writing?
 
General chit-chat
Help Users
    Psionic Roshambo @ Psionic Roshambo: BORTZ!!!!!