key clip - avr device not responding?

Discussion in 'Wii - Hacking' started by spe@rmint, Jun 25, 2008.

Jun 25, 2008
  1. spe@rmint
    OP

    Newcomer spe@rmint Newbie

    Joined:
    Jun 24, 2007
    Messages:
    2
    Country:
    United Kingdom
    hello wonder if anyone can help.

    when i try to update my key clip with the programmer through the parallel port i get the following error.

    avr device not responding
    initialization failed, rc=-1
    double check connections and try again.

    it gives me the same error if i try the programmer without the key clip and without the programmer even plugged in, so is it my parallel port?

    thanks!
     
  2. FireEmblemGuy

    Member FireEmblemGuy Finally hit 1000 posts

    Joined:
    Jul 6, 2007
    Messages:
    2,274
    Location:
    Michigan, USA
    Country:
    United States
    Try wiggling the chip around in the programmer a bit; that's usually the problem, it doesn't fit like it should.
     
  3. spe@rmint
    OP

    Newcomer spe@rmint Newbie

    Joined:
    Jun 24, 2007
    Messages:
    2
    Country:
    United Kingdom
    just pulled the clip out slightly and there you go, worked a treat!


    many thanks!
     

Share This Page