Hey!
My right joycon won't detect in connected mode. I've tried updating firmware on it, reseating the rail connector, etc etc. The plug to the ribbon cable is slightly messed upp (inside the joycon). I assumed this was the issue, but then I checked the voltage going to pin 4... It's at 6.9-7v when plugged into the switch. Is this normal? I thought that pin should be at 5v. Joycon does not charge.
The Switch however responds to RCM mode on pin 7 connected to 10, so those two pins work.
Don't have another joycon to test with.
Thanks a lot!
My right joycon won't detect in connected mode. I've tried updating firmware on it, reseating the rail connector, etc etc. The plug to the ribbon cable is slightly messed upp (inside the joycon). I assumed this was the issue, but then I checked the voltage going to pin 4... It's at 6.9-7v when plugged into the switch. Is this normal? I thought that pin should be at 5v. Joycon does not charge.
The Switch however responds to RCM mode on pin 7 connected to 10, so those two pins work.
Don't have another joycon to test with.
Thanks a lot!