Interesting

Discussion in 'Other Flashing Hardware & Software' started by Jaejae, Mar 22, 2008.

  1. Jaejae
    OP

    Jaejae Superfly Don't Used

    Member
    1
    Sep 23, 2007
    New Zealand
    Auckland, New Zealand
    So, I decided to flash my DS to the stealth FlashMe because I need to get it replaced, I couldn't find my flashing tool, so i just used a hex bit.
    I started FlashMe, pressed xbxb, and it started at 66%, then I stuck in the hex bit, and briged that point you aren't supposed to bridge, it turned off.
    I started it again, and it booted like nothing happened.
    Strange.
     
  2. paul1991

    paul1991 Banned

    Banned
    1
    May 5, 2007
    United States
    You already has FlashMe installed. 66% of your firmware(The protected bit) was already on the system. You were just overwriting some system settings.

    I bet if you look, you will find you have lost some WiFi settings along with all the DS system settings.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice