Install csio after softmii Install?

Discussion in 'Wii - Hacking' started by Sliddder, May 23, 2009.

May 23, 2009
  1. Sliddder
    OP

    Newcomer Sliddder Newbie

    Joined:
    May 23, 2009
    Messages:
    1
    Country:
    United Kingdom
    Hi

    I was hoping for some advice, I have searched both here and the Internet and not found an answer so I apologize if this is common knowledge or I missed a thread.

    I have just ran through the SoftMii 2.1.1 process on my 3.2E Wii. I have followed all the instructions and every thing seems to be installed fine. I have loaded up a Wolf3D through HBC and it loads fine. I have put a backup DVD disk in and that loads fine to. I have moved on to trying to load things through the USB Loaders (both Waninkoko's 1.5 and the Ultimate Loader from the thread in the boot loaders section) and each one failed with either error ret = -1 or error ret = -6 respectively.

    To cut my question short, does SoftMii install cISO36 Rev9/10 or do I have do to this after the whole SoftMii process?

    Again sorry if this seems stupid or is answered else where I have been searching for awhile.

    Thanks
     
  2. middeloni

    Newcomer middeloni Advanced Member

    Joined:
    Mar 14, 2009
    Messages:
    51
    Location:
    Netherlands
    Country:
    Netherlands
    well, it can never hurt to install this CIOS, be sure to download the rev 10 (or 11 when its released) Google to find it.
     

Share This Page