Hardware I need the value of this emmc cap

[hoyohoo]

Hey guys, I made another upsie and knocked the tiny cap near the emmc to the 9th dimension.

Can someone please provide to me the correct value? I randomly found a cap that would fit on my board holder, but I cannot tell if it is the right one. I measured it with 236 - 238 nF (or maybe pF? I forgot the unit, but the value was about 240 for sure. And it is the right size).

I never should have attempted to reball the emmc

 

[thesjaakspoiler]

That is just a cap to smooth the voltage line.
Something like 220nF should be sufficient (not pF).
I couldn't find the value for the emmc in the Switch but just take a look at this schematic with another emmc :
https://community.nxp.com/t5/i-MX-P...essage-images-1239066=138559i916899F3C2151471

 

[hoyohoo]

Ok thanks, I will wait for other people to respond. If everyone agrees, I would just solder this one I found.

 

[jkyoho]

measured less than 100nF(80 ish), I believe you could round it up and use 0.1uF/100nF

 

[hoyohoo]

Ok, thank you. I have enough of those.

Did you measure this on a v1? Mine is in the "maybe patched" list (or is it a v2 then?) and will not accept a payload, so I guess it is patched.

 

[jkyoho]

I don't think v1 or v2 would have different cap value on the emmc module. mine is measured on v2 motherboard emmc

 

[hoyohoo]

Ok, this seems to have worked, but I am back at the original fault, I cannot get past behind the switch logo. I already changed the WiFi chip with a brand new one.

I guess I will open a new thread for this