I need reassembly help! GBM

Discussion in 'GBA - Hardware, Devices and Utilities' started by ixenn, Oct 31, 2007.

Oct 31, 2007

I need reassembly help! GBM by ixenn at 10:44 PM (734 Views / 0 Likes) 2 replies

  1. ixenn
    OP

    Newcomer ixenn Newbie

    Joined:
    Oct 31, 2007
    Messages:
    2
    Country:
    United States
    My lcd in my micro was shot so I bought a cheap one on ebay that the lcd worked on and started working on putting it in mine that does work. Well i got everything apart but I cannot seem to get the thin ribbon inserted into the PCB, the big one slides in just fine. Does anybody have any experience at this? I have tryed needle nose and even pressing down with a flathead on the ribbon while trying to slide it in.. thanks for any and all help!
     
  2. ixenn
    OP

    Newcomer ixenn Newbie

    Joined:
    Oct 31, 2007
    Messages:
    2
    Country:
    United States
  3. dexmix

    Member dexmix GBAtemp Regular

    Joined:
    Apr 13, 2007
    Messages:
    268
    Country:
    United States
    you lift up the edge of the latch and fiddle with it to get clearance. they are both latches that lock down on the ribbon to keep it in place. you don't just shove em in, they slide in easily if the latch is open.



    good luck!
     

Share This Page