I build a mod chip into my switch sled but I got this screen what should I do?

[SplatG]

 

[linuxares]

Press Vol?

 

[SplatG]

Press Vol?

when I press vol it restarts and then same screen

 

[linuxares]

when I press vol it restarts and then same screen

hmm... got any pictures of your solder job?
Also which chip? Might need a reflash of the firmware?

 

[SplatG]

pictures of the solder job I can't show you right know because my switch is not here yet because my friend soldered my points again for me so I need to ask him first but this is the chip

Post automatically merged: Yesterday at 6:22 PM

I just know that the chip blinks blue and then yellow yellow but I don't know what we do know we resoilder the points like 3times + other cables and yeah and now when you turn on its just the screen

 

[linuxares]

Hmm its one of those generic chips. It's most likely running Picofly.
You should try to update it to the latest picofly and see if it helps.

 

[SplatG]

okay my friend answers me that he try to install the newest firmware and when does not help he send me the soldering points

 

[linuxares]

Hmm... I would look over the soldering if so. I never seen this issue before so I'm a bit stumped.

 

[SplatG]

mh yeah that's the problem why I find no solution for that xD

 

[linuxares]

You can check in the general Picofly thread or just wait for someone that knows more about the modchips to enter here

 

[alecocr20]

Hello,

If you remove the sd card do you get the no sd card message?
If so, delete all you have on the sd card and install an all in one package, I use HATS and see if it works.

I think if there was an issue with the soldering you would be on OFW or nothing at all

 

[jkyoho]

This kind of brief hekate menu only shows when missing bootloader folder or files from SD card