HWFLY Oled - Black Screen and chip shows no light whatsoever

[sigmaxf]

Oled got hwfly v3 installed, all was running well, trained and booted perfectly.
Started hekate and was creating the emunand(file) when the console shut off and won't turn on again. Battery was at 55% at this time.
Tried holding on/off button for 20s, nothing, charged for a couple hours, still does not turn on. Removed microSD, still, no signs of turning on.

Weird thing is that the light on the modchip itself does not even turn on, so pretty hard to debug.

Any ideas?

 

[thesjaakspoiler]

Did the hwfly maybe got disconnected partially or did you maybe bridge something that wasn't supposed to be bridged?
I'm afraid you will need to have a look inside again.
If the light of the modchip doesn't turn on then it's either the power to the modchip or the power rail itself that has problems.

 

[sigmaxf]

I uninstalled the modchip and the switch still does not turn on.
How fucked am I? Is there anything I can try?

 

[irvingoh999]

I uninstalled the modchip and the switch still does not turn on.
How fucked am I? Is there anything I can try?

Check for a bridge on the 3.3v power rail. If its bridged, try repairing it like a faulty switch, check the m92t36, p13usb and bq chips (capacitors around those chips) for shorts.

 

[mydudedontberude]

Did you end up fixing this? I've got the same problem.

 

[Hayato213]

Did you end up fixing this? I've got the same problem.

Not sure if you will get an answer from OP, haven't been here since last summer.