I was playing on SX ox core mod chip mariko. But I switch to atmosphere cause more cheats available. Every thing is good except I can’t play monsters hunter anymore it keeps crashing error game didn’t close right.
Synnand on 10.2 but emunand on 11.0.1 with the latest atmosphere installed using awooDid you install the sigpatches?
https://github.com/eXhumer/patches/releases/tag/v11.0.1-6
Additionally, what fw are you running? 11.0.0 or 11.0.1
The MHR update 1.1.1 requires fw 11.0.1. You can make it work by ignoring fw requirement during installation using Tinfoil or DBI or Goldleaf etc.
There shouldn't be a problem then. Check it you have the correct sigpatches for the version of atmosphere you installed. Atmosphere 0.18.1 had a silent update that required an updated sigpatches.Synnand on 10.2 but emunand on 11.0.1 with the latest atmosphere installed using awoo
Ok I’m going to download right now thanks I’ll report soonThere shouldn't be a problem then. Check it you have the correct sigpatches for the version of atmosphere you installed. Atmosphere 0.18.1 had a silent update that required an updated sigpatches.
Yeah I did used prebuilt kefir cause I didn’t know how to switch from SX to atmosphere cause I have mariko modded chip. My sysnand on 10.2 cause I don’t want to update to lose SX, but I did the update on Emunand using choidujournx 11.0.1 I’ll get another sd card and try again thanksDo you have a spare SD card? Maybe try from scratch on there.
Download the latest atmosphere from https://github.com/Atmosphere-NX/Atmosphere/releases/tag/0.18.1
Download the latest sigpatches from https://github.com/eXhumer/patches/releases/tag/v11.0.1-6
Use hekate to create your emunand https://github.com/CTCaer/hekate/releases/tag/v5.5.4-v2
Always load atmosphere using fusee_primary
I would advice not to use any prepackaged release like kosmos, deap sea, shallow sea, and the like because it is difficult to figure out if something goes wrong.
For further setup you can also check this https://rentry.co/mys8q
Remember MHR requires firmware version 11.0.0 and the latest update requires firmware 11.0.1. The update can work on firwamre 11.0.0 but it requires Tinfoil or similar to ignore firmware requirements during install.
Thanks it only work with new emunand creating with atmosphere no migration really appreciate your helpOk for Mariko kefir is the worst pack to use.
Follow the guide here https://rentry.co/mys8q
Also for atmosphere do not use choidujournx. Use choidujournx for sx only. Use Daybreak on Atmosphere.
For my Mariko switch, here is what I did.
1. backup my boot.dat and license.dat
2. use a fresh SD card and copy only boot.dat and license.dat
3. Create a new emunand partition
4. copy the latest atmosphere files to SD card
5. Copy matching latest sigpatches
6. Copy daybreak homebrew
7. Copy fw 11.0.1 folder
8. Hekate files
9. Rename hekate bin file to payload.bin file and place in root of SD card
10. Download the sx gear boot.dat and replace the original sxos boot.dat in root of SD card
11. Copy hekate bin file, fusee_primary.bin to sd:/bootloader/payloads/ foldee
Boot up switch and it should now load hekate. Select atmosphere in the boot selection or go into payloads and select fusee_primary.bin
Atmosphere will load for 30 to 60 seconds
Go to album and select daybreak. Follow the prompts to update emunand to 11.0.1
Ensure you have the exosphere.ini in root of SD card to prevent ban.
But all of this steps is here https://rentry.co/mys8q